Apps aren’t always convenient. Voice control isn’t always suitable. Remote controls are always on hand and always for everyone. With NanoMotes, everyone in your home has easy control of your smart home whether they’re at home, coming or going.
NanoMote One and NanoMote Quad communicate directly with your Z-Wave gateway. That means that they can control anything connected to that gateway, whether that’s one device at a time or a group of devices all at once, even electronics that aren’t Z-Wave.
Your whole home.
NanoMotes are simple to setup. Sync it with your Z-Wave gateway and then assign individual devices or Autopilot scenes to any button.
More control isn’t always a good thing, that’s why we’ve designed two models of NanoMote; One and Quad. NanoMote Quad is the full package, offering 4 buttons capable of control up to 12 Autopilot scenes. NanoMote One cuts control down to its purest form, offering 1 button for use as a panic button, garage door controller, or whole room or home controller.
NanoMotes are tiny. At only 50x50x14 mm, they’ve been designed to slide onto a table, slip into your pocket or connect to your keychain. NanoMote One and NanoMote Quad both come with an optional, key chain loop for simple day-to-day portability as a Z-Wave key fob.
Remote controls don’t have to be portable – they just have to be wireless. Like our WallMote Z-Wave switch, NanoMote can be placed or mounted just about anywhere in your home. Whether it’s beside your bed or somewhere else, NanoMotes make it easy to add simple smart home control anywhere in your home.
Accidents happen. But to ensure that NanoMotes aren’t causing them, it’s been crafted with an inbuilt pin lock. Simply hold down your secret combination of button presses to disable your NanoMote and then do the same again to enable it.
Perfect wireless range.
NanoMotes are designed to be used inside your home and outside of it. To make that possible, they need a wireless signal optimised for distance. NanoMote One and NanoMote Quad can communicate over distances of 328 feet / 100 metres, with signals repeated via Z-Wave when NanoMotes can’t communicate with your gateway directly.
Perfect battery life.
Aeotec knows the importance of rechargeable batteries in remote controls; it was the foundation of our best-selling MiniMote. Both NanoMote One and NanoMote Quad build upon that, offering an even more compact battery with up to 6 months battery life alongside easy 5 hour recharging via USB.
Rechargeable and replaceable.
NanoMotes can be easily recharged via USB; but all batteries eventually get a shorter life span. When that happens, there’s no need to replace your NanoMote. Simply remove the backplate, insert a new LIR2450 3.6 volt battery, and full, rechargeable battery life is yours again.
Ready for outdoors.
Designed to be portable, NanoMotes are ready for outdoors. Engineered to the IEC’s IP54 standard, NanoMotes have been crafted with resistance against accidental exposore to water splashes and dust.
Cutting edge Z-Wave.
So that they can control so much of your smart home, NanoMote One and NanoMote Quad are crafted with Z-Wave Plus inside. That lets them control Z-Wave devices from any manufacturer along with older devices no matter which generation of Z-Wave they were built with.
Cutting edge security.
They can control entrances to your home such as garages and door locks, and they do so securely. Each NanoMote includes Z-Wave S2, enhancing the remote control with 3 separate layers of security to help stop hacking, cloning, and unauthorised control.
NanoMote, the successor to Aeotec MiniMote, is available from the following Aeotec resellers;
NanoMote will be availble for Z-Wave connected homes in other countries across 2019. Get a notification when it’s released by signing up to Aeotec’s notification service below.
Aeotec has a number of new products in development for 2019, with the next of them to be announced in the near future. To find out what's new and when they're released, be sure to sign up to our newsletter.